Most people do not understand how a nail making machine can make nails at one time, the following is a brief introduction: feeding.

First put the suitable diameter of cold drawn wire or steel bar through the wire feeder into the fixture; Clamping, nail making machine according to a series of transmission systems such as camshafts to clamp the fixture, which is convenient for punching nail caps; After punching the cap, the clamp is clamped, and the punching needle presses the azimuth of the fixture according to the promotion of the camshaft, and then breaks through a nail cap; Cancel the punching needle, after the nail cap is broken, pull the punching needle back according to the camshaft; Disconnection, in the whole process of punching needle pulling, the nail cutter carries out the actual operation of disconnection according to the other camshaft, it is worth mentioning that the disconnection not only cuts out the length of the nail with the cold drawing wire, but also cuts out the nail tip separately. If the work content of the nail making machine is subdivided like this, it is relatively slow, and more than 300 nails can actually be produced per minute, and the operation process seems to be another work in the human eye.

The usual maintenance of the nail making machine is originally the top priority in daily affairs, and the old repetition is mainly for beginners in the nail making industry, and the purpose is still to remind the old irons to pay attention to the daily maintenance of the nail making machine. One of the daily maintenance is to increase the service life of the nail making machine, and in addition, to ensure the production of nails to meet the standard, after all, the equipment in addition to some common failures, then the residual nails are inevitable.

After the nail making machine is installed, it must run empty load for half an hour, which is because the new equipment does not go through the running-in period when it comes to the scene, and the full load operation actually has the effect of a running-in period. Usually in the production and manufacturing should also pay attention to moistening, each shift oil dripping frequency should not be less than three times, the lubricant is guided by unsalted butter, put some unsalted butter before starting, and then carry out oil dripping from time to time in production and manufacturing. Pay attention to whether the tightening screws of each part are loose, because the principle of the nail making machine causes a certain vibration of the nail making machine, then such vibration will be likely to cause some parts of the screws to loosen the situation, if long-term neglect, it will cause a variety of common failures.

For more details of the nail making machines please contact with us.