Always dedicated to the quality of product. ​
What to do if the nail cap produced by the nail making machine deviates from the top and bottom
来源: | 作者:heifeixintian | 发布时间: 2023-08-02 | 140 次浏览 | 分享到:

Nail making machine is a device for producing nails. If you find that the nails produced by your nail making machine have a deviation of the nail cap, then you need to check if it is due to insufficient hot pressing.

 Usually, the problem of insufficient hot pressing in nail making machines may be caused by insufficient temperature. We can solve it through the following aspects:



1. If it is found that the hot pressing head of the nail making machine cannot heat properly, it is necessary to replace the hot pressing head in a timely manner.



2. If foreign objects are found inside the hot pressing head, it is necessary to clean them in a timely manner.



3. If water is found inside the hot pressing head of the nail making machine, it is necessary to drain the water to prevent it from corroding the nail making machine.



I、 Uneven feeding of nail making machine



1. Incorrect feeding device, such as foreign objects or incorrect position on the feeding device, can cause uneven feeding. In this case, the nail machine should adjust the feeding device to the appropriate position. In addition, the feeding amount of the nail making machine should be adjusted to an appropriate level to ensure uniform pressure on the nail heads on the nail board.



2. The feeding device is not properly matched with the guide roller. If the guide roller of the nail making machine and the feeding plate are not well matched, it will cause one side of the nail plate to be tightly pressed and the other side to be loose. Therefore, it is necessary to maintain good coordination between the guide roller of the nail making machine and the feeding plate.



3. The size of the steel balls on the feeding device is not appropriate. When the steel balls are too large, it will cause the nail board to deflect towards the smaller side; When the steel ball is too small, it will cause the nail board to deflect towards the larger side. Therefore, it is necessary to maintain the appropriate size of the steel balls.



4. The gap between the feeding device and the guide roller is too large or too small, which can affect the feeding amount. When the gap is too large, the feeding device will move forward, while when the gap is too small, it will cause the nail to move back.



II、 Feeding mechanism failure




1. The limit switch on the feeding mechanism is not sensitive, so we need to check it and replace it if it is not sensitive.




2. The motor on the feeding mechanism is damaged, which requires replacement. Generally, the motor on the feeding mechanism is connected to the motor shaft, so we also need to replace it.




3. The pressure of the conveyor belt is too low or too high, and at this point we need to adjust it to the normal value.




4. If the conveyor belt is bent or broken due to being too long, we need to replace it.